Vortech Universal Big Block Carbureted System Manual de usuario descargar pdf (Pagina 11)

P/N: 4GA020-030

08DEC08 V3.0(BBC LowMount(4GA..030 V3.0))

A. Remove the stock 1/4" hex head pipe plug

from the front left lower portion of the engine

block, if equipped, and replace it with the kit

supplied 1/4" socket head pipe plug.

Replacement of the square head plug allows

for supercharger bracket installation clear-

ance. Apply Teflon paste sparingly to the

plug's threads prior to installation. (See Fig.

3-a.)

B. Remove stock oil pressure transducer, and

install in its place an 1/8" straight "T". Orient

the fitting to allow for suitable installation and

routing of oil supply line. Apply engine oil to

the male thread prior to installation. Next,

install the 1/8"NPT x 45° male elbow into the

side port of the straight "T" (see Fig. 3-b).

Thread one end of the oil feed hose onto the

1/8"NPT x 45° male elbow. Use a small

amount of oil when installing the flare type oil

feed hose assembly. Route the hose towards

the front of the engine; keep the free end

capped to avoid contamination.

3. SUPERCHARGER OIl FEED

GOES TO

SUPERCHARGER

OIL SUPPLY NOZZLE

TYPICAL OIL FITTING ASSEMBLY

• USE ONLY OIL ON FLARE

TYPE FITTINGS. DO NOT

USE TEFLON PASTE OR

TAPE ON FLARE END

NO. PART DESCRIPTION QTY.

1 7P250-120 Socket Head Pipe Plug 1

2 N/A Oil Pressure Transducer 1

3 7P125-034 1/8" Straight “T” 1

4 7P125-103 1/8" NPT x 45° Male Elbow 1

5 4MA145-020 Oil Feed Hose 1

Fig. 3-a

Fig. 3-b

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Sin comentarios

Vortech Universal Big Block Carbureted System Manual de usuario Pagina 11